Repair: Blue Screen Error 0x0000000a (Solved)

Updated October 2024: Stop getting error messages and slow down your system with our optimization tool. Get it now at this link

1. Download and install the repair tool here.
2. Let it scan your computer.
3. The tool will then repair your computer.

Many BlueScreens are caused by old or damaged drivers, especially video drivers, but there are other causes. The error message Stop 0x0000000a means that a process or driver has attempted to access a memory area without authorization. It is also known as IRQL_NOT_LESS_OR_EQUAL.

This stop error is output when accessing the reverse (or invalid) memory when the IRQL value is too high. The error that causes this error check usually occurs after a defective device driver, system service, or BIOS has been installed.

If you experience a 0xA error check when upgrading to a new version of Windows, this error may be caused by a device driver, system service, antivirus or backup tool that is incompatible with the new version.

RAM test

If this problem still persists with your computer, it’s time to test your computer’s RAM using third-party memory scanning software on your computer, then replace the USB stick if you found it defective.

You can also consult my tutorial on RAM testing and troubleshooting methods to know if your RAM is really in good condition or not.

Scan for viruses and fix the registry.

If all the methods described above do not correct the 0x0000000a shutdown error on your PC, it means that your computer is affected by an infection virus or that the problem is associated with the registry such as disk fragmentation and invalid entries.

Check your system using the system file checker.

You should be aware of this point that Windows itself offers you various system audit options that you can use from time to time to get various benefits and solutions. One of these possibilities of Windows is the System Utility Checker. It can scan and repair/restore corrupted system files. The necessary steps are listed below:

Open the Start menu
Enter the command, hold down Ctrl+Shift> Press Enter now.
A dialog box appears asking you for authorization.
You will see a black box with a blinking cursor (This is the command prompt).
Type “sfc /scannow” on the screen and press Enter.

After a few minutes, you will see a confirmation message that a corrupted file has been detected and successfully repaired.

Registry Clean-up

The registry is a large database on which Windows relies. It stores information from your latest emails, wallpapers and even your hardware settings. The registry is an important part of Windows, but also a major cause of the stop error 0x0000000a. The registry stores many hardware references that the Windows operating system needs to work. Many of these references are often damaged or damaged, which means that your computer can no longer read them. This can cause the Stop error 0x0000000a, because Windows cannot read your system’s hardware references.

The article above deliberately focuses on the error of the blue screen 0x0000000a, what the causes are and how to correct them with the best possible solution. Therefore, you must be sure that you can solve the blue screen problem with one of the solutions mentioned above. And most importantly, you don’t have to worry about your device’s data and you can rely entirely on recovery. Good luck and you can start working on your system without hesitation.

If one of these methods works for you, you will never see the 0x0000000a stop error again.

https://answers.microsoft.com/en-us/windows/forum/windows_7-hardware/blue-screen-error-stop-0x0000000a/f508aab6-626c-4ef7-9908-2840ce6dec0f


Expert Tip: This repair tool scans the repositories and replaces corrupt or missing files if none of these methods have worked. It works well in most cases where the problem is due to system corruption. This tool will also optimize your system to maximize performance. It can be downloaded by Clicking Here